Where the test leads are unspecified, typical test leads shall be used. The test leads shall be connected and arranged in a typical configuration for each operation mode, according to Figure If the test leads recommended or supplied are longer than I m, each one should be bundled so that the test object is in a horizontal distance of 1 m to the ELJT.
The test leads shall be arranged 0,1 m apart in a horizontal position on the test table. Tags: Electrical equipment for measurement. ASME standards. This equipment might also be used in areas other than laboratories. Equipment within the scope of this document might be operated in different electromagnetic environments; depending on the electromagnetic environment different emission and immunity test requirements are applicable. Corresponding immunity test requirements are described in Clause 6.
The corresponding emission requirements are described in Clause 7. The specified emission and immunity requirements aim at achieving electromagnetic compatibility between equipment covered in this document and other equipment that might operate at locations with electromagnetic environments considered in this document.
For dated references, only the edition cited applies. For undated references, the latest edition of the referenced document including any amendments applies. IEC pdf free download. Tags: control and laboratory use Electrical equipment for measurement.
0コメント